| Repairing Balconies |
SURFACE PREPARATION
Step One
- A) Clean surface, remove grease or any bond inhibiting substances.
Note: Pour equal amounts of A and B EPO-TOXY™ and stir each container thoroughly. Resin and hardener are manufactured with multiple viscosity products. It is important to stir or roll prior to mixing.
Note: Pour equal amounts of A and B EPO-TOXY™ into mixing container. Add silica sand at a ratio of four parts sand to one part thoroughly mixed A & B compound. Repair all holes, cracks and pit marks in surface to be repaired
Step Two
- C) Pour equal amounts of A and B EPO-TOXY™ into mixing container,(Plastic or metal). Stir until one color. Add #4 sand at 2:1 ratio.
- D) Add small amounts of color pigment while stirring, if desired.
Step Three
- E) Apply mixed EPO-TOXY™ compound to surface with paint type roller or trowel approximately 1/16" thick.
- F) Broadcast fine sand blasting sand evenly over surface.
- G) Let surface set approx. four hours. (Depending on out side temperature.)
- H) Sweep surface clean.
Xylene or any aromatic solvent is used to clean up tools. Tools may be cleaned up with water if EPO-TOXY™ is still wet after installation.
