Repairing Ruts, Holes and Pit Marks in Concrete Surfaces

---

SURFACE PREPARATION Step One

• A) Clean surface, remove grease or any bond inhibiting substances.
• B) Stir EPO-TOXY™ thoroughly. Resin and Hardener are manufactured with multiple viscosity products. It is important to stir or roll prior to mixing.

AREA TO BE WORKED ON SHOULD BE DRY FOR BEST RESULTS


MIXING PROCEDURE Step Two

NOTE: Pour equal amounts of A and B EPO-TOXY™ into mixing container. Add silica sand at a ratio of four parts sand to one part thoroughly mixed A & B compound. Repair all holes, cracks and pit marks in surface to be repaired.

Xylene or any aromatic solvent is used to clean up tools. Tools may be cleaned up with water if EPO-TOXY™ is still wet after installation.

Lone Star Epoxies Telephone: (972)475-2501 Fax:(972)412-9036		P.O. Box 121 Rowlett, Texas 75030-0121
Fischl Enterprises, Inc. dba Lone Star Expoxies

- Decorative Flooring
- Industrial Flooring
- Chemical Resistant Coatings
- Abrasive Surfaces
- U.S.D.A. Approved Materials
- Waterproofing Materials

Contact Us   HOME

CONCRETE REMEDIATION EPO-TOXY™ FLO-RITE 7000 CR-60 ELASTA GEL SUPER~SEAL ELIMINATOR ORGANO-ETCH

Sub-Floor Underlayment    Spalling, Scaling, Sealing   Walkways   Cracks, Domant   Cracks, Moving  Balconies   Overlaying & Resurfacing   Stair Steps   Anti-Skid Surfaces   Ruts,Holes & Pitmarks   Expansion Joints   Concrete Mortar